EDGE PFAS

Solvent bottle, glass, GL45 treaded, 1L for the EDGE Extraction System.

Q-Cups are coated aluminum sample holders for the EDGE Extraction System. Q-Cups consist of a cylinder piece which holds the sample, and a threaded bottom piece which holds the Q-Disc filter. This kit includes 12 Q-Cups, which is the maximum number of samples that can be extracted in a run. For efficiency, it's recommended to have two sets (24 Q-Cups) and two Glass Vial Racks. This would allow one set to be ran in an EDGE, while another set is being prepared.

Includes

• 12 Q-Cup Cylinders
• 12 Q-Cup Threaded Bottoms

Calibration tool used to aid in the calibration of the EDGE Extraction Systems autosampler. The the black cap should be inserted into the autosampler fork.

Calibration tool used to aid in the calibration of the EDGE Extraction Systems autosampler. The the silver post should be loaded into the postion to be calibrated on the EDGE Extraction System.

Fittings used to connect the vent line tubing and drain line tubing of the Waste Bottle Assembly to the EDGE Extraction System.

The side enclosure attaches to the open side of the EDGE and can be used to increase the airflow and create a clean environment in the rack area.

Compatible with the 60 mL EDGE system only. Refer to part 525320 for the for the side enlcosure for the 40 mL EDGE system.

The Waste Bottle Assembly collects the waste for the 60 mL EDGE Extraction system. The 2 L bottle and cap equipped with a level sensor is connected to EDGE Extraction system by vent line tubing, drain line tubing and level sensor connector.

Removable rack for the 60 mL EDGE Extraction system that holds twelve Q-Cup Sample Holders and twelve 50 mL centrifuge tubes.

Barcode scanner